wifi controller

We need a wifi module that can be connected to electronic devices around the house. The device can then be controlled with an smartphone app through a wifi network. So the remote control/switch will be replaced by a smartphone app. For prototyping we want a wifi module (including micro controller) that can be connected to any tubular motor (that can open and close the window blinds) There are two kinds of tubular motors: 1) that is connected to an electric switch, with two buttons for opening and closing the blinds. 2) that is connected with radio frequency to a remote controller --> The wifi module should be placed on both types of tubular motors. The wifi module should be programmed (in Arduino or other language) to accept the following commands: - connect device (tubular motor) - disconnect device (tubular motor) - enter start point of tubular motor (so the app knows when the blinds are fully opened) - enter end point of tubular motor (so the app knows when the blinds are fully closed) - open (roll up blinds, cannot roll further than the start point) - close (roll down blinds, cannot roll further than the end point) A smartphone app with these 6 functions. The results of this project are: - list of manufacturers of the wifi modules (preferably 3 or more) with prices - list of manufacturers of tubular motors (preferably 3 or more) with prices - 10 wifi modules, programmed with Arduino - source code of Arduino - cable and manual to install the program on the wifi modules - test case with tubular motor (50nM) - manual how to install the wifi module on the tubular motor - source code of smartphone app - manual how to use the smartphone app