Bandsaw automation

hi, i can help

Hello, I can do this job.

I have worked on sophisticated projects in automation from programming ECU's to Automation, Please read my Message!

I am an Electronic Engineer with 20+ years of experience developing automation solutions.

Dear Sir, We are Reserach and Development company whose working area are : -Digital Motor Control -Analog Design -Electronic Design -Power Electronics -PCB design -Embedded system -Matlab -Simulation of hardware For each concept descriptions are as follows: Digital Motor Control: -3-phase induction motor vector control drive -Flux estimation algoritm generation -DSP(TMS320) implementation on motor drive -Low speed application -Torque and speed loop generation -Control algoritms Analog design -Low power distribution -Noissless special opamp based analog circuits -Analog filters -Orcad simulation of several circuits Electronic Design -RF transmitter and receiver -Bluetooh reader and transmitter -Magnetic reader Power Electronics -Implementation motor drive -AC/DC converter -DC-DC converter -Battery charger -Solar inverter -Renewable Energy simulations -Uninterruptle power supplies PCB design -Schematic design by Altium -PCB design by Altium -Power board design -SMPS board design Embedded system -PIC18,PIC24,PIC30 and dsPIC applications -Ardino -MSP430 -Atmel -DSP(Texas Instruments) -Renesas Matlab -Power Electronics simulation -Motor drive -Wind Energy -Solar Energy -Control applications Simulation of Hardware -Orcad Simulation(TI,National, Linear Tech, Maxim libraries) -LTI -National -Matlab Very important Note: References attached. Please look excel file to see projects which we made until now! Note: Payments will be funded as: 1)Initial:%25 2)Second stage:%15 3)Third stage:%20 4)Final stage:%40 Metin Akin

Hello, I'm an automation engineer more than 30 years. Please see my CV. My best regards

Hi Project Manager, I have good experience in Arduino programming. As per my understanding, I am hereby proposing my solution to the stated situation. I have an Arduino board already in my inventory. I can integrate it with PHI board stated and accordingly control the Bandsaw machine. Kindly elaborate it more. Regards; Amit