Firmware development using STM32F407
₹37500-75000 INR
Paid on delivery
Looking for Firmware engineer experienced in STM32F407 development.
- Should have experienced in CAN protocol and SPI.
- Looking to work from Pune, India. Not mandatory though.
- Details about the requirement will be shared with the suitable candidate.
- Open position for Full time employee or part time developer.
Project ID: #31824508
About the project
14 freelancers are bidding on average ₹67107 for this job
Hi there, I have almost 13 years of experience. I have read the details and have a few questions. Please get back to me to discuss it further. Waiting for your reponse Thanks.
Hi, I hope you are doing fine. I am an expert in C programming, Microcontroller (AVR, ARM and etc), Arduino and Python.I have done some simulation and testing various type of Microcontrollers and sensors. I have exper More
I have more than 7 years experience in embedded hardware and firmware development . So I can do your job within a time limit with your satisfaction.
• GPRS(etc) I am specialist in development and interfacing between Android application and arduino board. hardware designing for embedded hardware. software development for embedded hardware. Home automation. More
Hi, I have expertise in STM32 and embedded systems, CAN,SPI etc. Refer my profile for details. Please send me detailed requirements. Thanks.
Hello, I have 10+ years of Embedded product design with multiple domains like a consumer, industrial, automotive, IOT and wearable product. -Hardware architecture design using MCU, controller, and FPGA, as well as low More
Hai sir I read your project details I can support your project end to end feel free to contact me I give a support
I designed firmware and hardware of an OBD device with STM32407 and Siliconlabs' chip BGM121. I think my experince with the OBD project fullfills the requirments of your project and shortenst the project development ti More
Hello, I am electronics engineering graduate from mumbai university. I have also done embedded system course. I have worked on few embedded projects. I have experience with different microcontrollers and can program in More