I need you to develop a program which can be run in MATLAB or in similar software where I can stimulate working of the following Arduino process.
Step1: RFID reader reads the tag.
Step2: Once the tag is confirmed, the Arduino rotates the stepper motor by +180°.
STEP3: Stepper motor automatically turns -180° after 10 seconds
STEP4: END and repeat.
6 freelancers are bidding on average ₹925 for this job
Hi, I am kahan. I am an embedded developer and have much experienced in the hardware and software side. Waiting for further discussion. Time and cost will be given after the discussion. Thank you.