I'm working on an IoT prototype based on Arduino. Ultimately I’m looking to send an image to an ePaper display through a local network (or over the internet).
To successfully create this code you will need an IT8951 board or be familiar with it.
The goal is to use an ESP32 board to receive the image wirelessly from LAN (ideally from POST from a webserver) and pass it on to an IT8951 chip to power the display (open to alternative suggestions if you have any).
I have an ED060KC1 (1448×1072) 16 grayscale display and IT8951 driver HAT:
[login to view URL]
and an ESP32 board.
[login to view URL]
I'm totally new to Arduino, but have a basic knowledge of C++.
So far I’ve been able to wirelessly load an image onto a lower resolution display driven directly by the ESP32 using some code from waveshare, and also loaded a small image onto the ED060KC1 that was stored on the ESP32 and passed to the IT8951 (using some code from GitHub) – so I know it must be possible to do it wirelessly, however I lack the knowledge/skills to do so.
*Note* This display is NOT one that can be driven directly by the ESP32.
10 freelancers are bidding on average £167 for this job
Hi! I am an Electronic engineer, microcontroller, C programming expert having past experiences with arduino, pic, AVR, chipkit and Texas instruments microcontrollers I am waiting for you over the chat. Thank you!
Hi. i read your description and understand your requirements. I am a AI and robotics engineer. i have good knowledge about Arduino and ESP32 contact me to discuss farther in details. Best regards MJK.
hi, I am a electronics and communication engineer with more than 2 years of experience. I have done this kind of work before. So I think I can do your work. Let's discuss more over chat.
Greetings, I am an electrical engineer with several years of experience in embedded systems. This project you posted is curious, and I would like to discuss further its details to achieve the best outcome possible.