OBLORA
Objective; a device that can report to the server, the status of its host at all set instance.
Reports; we have three (3) types of report aiming to receive from this OBLORA device, which are
a. GPS; with a mobile GPS it should at all-time be able to ping its current location correctly
b. OBD2; it should be able to scan the host device at set interval to report if any FAULT seen. The following can be read
1. Any of the air bag sensors
2. Electrical problem
3. Transmission problem
4. etc
c. I/O; this consist of 20 input system, it helps to keep the server updated with the current status of the connected part.
The following can be connected
1. Break light status
2. Head lamp
3. Left or right indicator lights
4. Wiper status
5. Ignition would also be turned OFF/ON from the server via this medium
Memroy; upto 5Mb, to allow the device log its last 10mins reports incase there was an internet disconnection.
Power; this device is powered by the host body
LoRa; communicates with the LoRa gateway
MCU; cordinates the entire process, each MCU to bear its unique ID, firmware to be enbedded into it
First of all I need to know if the OBD2 prototype has GSM/WiFi/Internet connectivity. Then are those input signals already defined, so that I only have to write the code to generate the suitable status to report. If you answer yes to above questions, I would like to propose a bid of 800$. Otherwise I have to do all from scratch, meaning takes too much time. I know what you're going to do. Good innovation. Good luck.