I am building a custom fpv racing quadcopter and need to make a power distribution board, with some built in electronics, like two voltage regulators (BEC) for 12 and 5v, an LC filter for filtering power to the fpv camera, OSD (on screen display), OpenLog data logger, and buzzer. Input voltage is between about 10v and 24v (need a little overhead too). Traces for speed controllers (4x V and G, full source voltage, as well as signal and ground from the speed controllers to the flight controller)... also from the voltage regulators to the camera (solder pads) through the LC filter and OSD to the video transmitter (solder pads). There should be a microJST plug to connect the data logger to the flight controller via cable. There will be solder pads for the buzzer. Should be using SMD components wherever possible. I can provide some schematics of each piece (might only have gerber files for some), so mostly just need you to try and fit it all into the shape and size I need. I've attached some images of a couple different PDBs that are for a different frame. Same stuff, different layout.
Hello! How are you!? I think I have the skills you need for this project! Please send me a message to talk more about your project! Please look at my profile! Have a nice day!
I have read and fully understood your requirements..
Please open chat to discuss further…
_____________________-----------------------------------_____________________________------------------
i have bulit a drone myself for a water monitoring system. the components you have listed out to use in your system is quiet resembles mine too. i assure you my best work , which il help you definitely. and i would like to clarify certain doubts....
1) do u need to fit inside the board u have given in the zip?
2) do u need the complete circuitory or just layout?