Controlling Boom Gate

Closed Posted 7 years ago Paid on delivery
Closed Paid on delivery

Control boom gate operation, boards have been made using pic 24F which has an LCD display screen currently has 5 outputs & 8 inputs & uses an AWS XXXX to read angle of output shaft this is the limit switch. This board controls the stepper motor driver.

Basically a command is received from a momentary contact to raise gate. Stepper motor ramps up, then ramps down until desired angle is detected then stops, waits for loop detector to be cleared then lowers with ramp up, ramp down until desired angle is detected. This is the basic. But options are to have RGB led in arm showing red green and amber as traffic lights and flashing red all the time when arm is down, Electro magnet option de-energises 1 sec b4 boom opens. The parameters need to be adjustable & there are 4 push buttons on the board for this. LCD screen shows the adjustable settings in config mode & in auto mode shows what is happening with the boom gate. This is the basics required

C Programming Electronics Embedded Software

Project ID: #11454605

About the project

11 proposals Remote project Active 7 years ago

11 freelancers are bidding on average $706 for this job

mechatronicsengr

Hi, I have expertise in similar projects. I have worked on LCD, PIC controller and other modules you have mentioned and I can execute this project in less possible time. Looking Forward, Khawaja

$526 AUD in 3 days
(74 Reviews)
6.8
loi09dt1

Please contact me to discuss further. Thanks

$450 AUD in 10 days
(96 Reviews)
6.4
xpressionlab

Hi We are a design consulting practice with a wide array of services. We have gone through your basic requirements and will give you a solution using a 8bit mcu, LCD and additional IOs as required. You will get a co More

$555 AUD in 40 days
(8 Reviews)
4.9
prashushinde9

Hello, I understood the initial scope of this project. Although i want to discuss further this job in order to prepare the final concept for this project. After Complete discussion over the call or in chat, i More

$773 AUD in 10 days
(1 Review)
3.0
ArsalanMansoor

Hi, I have 4 years experience of developing firmware for PIC24H series microcontrollers using C language. I can complete your task in the given time in a very good way. I look forward to hearing from you. Best More

$555 AUD in 5 days
(1 Review)
1.2
KarimUc

I have experience with PIC16, PIC18,PIC24, AVR's, ARM based controllers, very good programming experience from working for a multinational company.

$333 AUD in 6 days
(1 Review)
0.4
denysetyo

A proposal has not yet been provided

$466 AUD in 5 days
(0 Reviews)
0.0
vimalkumar1

A proposal has not yet been provided

$777 AUD in 25 days
(0 Reviews)
0.0
hardikharpal

A proposal has not yet been provided

$555 AUD in 10 days
(0 Reviews)
0.0